edis with stimulator?

jakeb · Post by **jakeb** » Sun Jun 25, 2006 7:53 pm

Once you do the edis mods to the megasquirt board will the stimulator still work with it or no?

The reason I ask is I just did all the mods to my board and when I hook up the stimulator the fuel pump light blinks and then goes right out. So I am worried that I may have damaged the board. Is this so or...is it just how it works?

If so is there a mod for the stimulator to get it to work again?

tia,
Jake

jakeb · Post by **jakeb** » Sun Jun 25, 2006 9:48 pm

And if the stim should work fine with it.. Where do I start to try and fix the problem?

I checked my changes to the MS board about 10 times so I am sure it is right.

jake

ASTB · Post by **ASTB** » Sun Jun 25, 2006 10:26 pm

Hi,

look here

http://megasquirt.sourceforge.net/extra/faq.html

Maybe it is the solution.

kind regards

ASTB

jakeb · Post by **jakeb** » Mon Jun 26, 2006 5:09 am

I checked there, tired checking and seeing if it was giving an error. Nothing at all

Tired to use hyperterminal and nothing. Brand new 9v on the stim.

The fuel pump and fidle lights blink one time and then nothing.

jakeb · Post by **jakeb** » Mon Jun 26, 2006 5:21 am

Also I when I did the mod I had a mistake...I had a wire going from the bottom of R10 to the band of D5 when it should have been the band of D9. Could I have caused some damage here?

jake

jakeb · Post by **jakeb** » Mon Jun 26, 2006 5:47 am

Problem fixed..... it is always the simple things.

PIC was out of the socket a little...i pushed it down in all the way and all is fine