Daughter Board Help

All Megasquirt 1 support questions. See also the Documentation

Moderators: jsmcortina, muythaibxr

Post Reply
superchargingmachine
Experienced MS/Extra'er
Posts: 348
Joined: Tue May 04, 2004 3:46 pm
Location: Illinois, Central

Daughter Board Help

Post by superchargingmachine »

I bought a daughter board a long time ago it is the one with the 1" square proto area in the top right or bottom left depending on how you look at it. Can anyone point me to the BOM or thread on this card?

The card says "MSnS_extra Harware board 1 v02"
"Design Marcus Sundin"
Marcus
Helpful MS/Extra'er
Posts: 67
Joined: Thu Nov 18, 2004 9:40 am
Location: In the middle of Sweden: Långsele
Contact:

Post by Marcus »

Bom: http://www.gpz900r.se/ms_e.htm

The thread is lost due to the 6 months rule, no posting in the thread and it goes Bye-Bye.
I think the guy that ran the board sales "gngrbrd_man" had a better Bom but I didn´t save a copy.

I have attached a copy of the Bom but check the link for more info.
Marcus Sundin
GPZ900R A5 Restoration & Modification
www.gpz900r.se
superchargingmachine
Experienced MS/Extra'er
Posts: 348
Joined: Tue May 04, 2004 3:46 pm
Location: Illinois, Central

Post by superchargingmachine »

Thanks for the quick answer that was the link I remembered! I am going to try this thing out this weekend. I have had the components for a while and never put them together.
superchargingmachine
Experienced MS/Extra'er
Posts: 348
Joined: Tue May 04, 2004 3:46 pm
Location: Illinois, Central

Post by superchargingmachine »

I don't think anyone is foloowing this link but just in case. I believe the silkscreen for the transistors at least for the output circuits is reversed on this board. This causes the circuit to go 12V in the on position and 3-8V in the off position.
Post Reply