I've kinda new to this MS'ting. I've been running a v3 board with the standard code for a few months with out too many problems, until today! I've just upgraded to MSnS-E and spent a while putting in all the constants and enrichment settings, but the car just wont run. It will start but wont run. Well, thats not totally true, if you keep pumping the throttle it will just about stay running.
I'm running MSnS-E just doing the injection at the moment, are there any settings that I've missed? I downloaded the MSnS-E code this morning, so it should be the lastest version.
The car is a N/A Pug 205 GTi 1900cc, 4 Cyl.
Any ideas?
Problems after upgrading to MSnS-E.....
Moderators: jsmcortina, muythaibxr
-
- MS/Extra Newbie
- Posts: 17
- Joined: Tue May 02, 2006 10:31 am
- Location: South West Coast, UK
Problems after upgrading to MSnS-E.....
Supercharged 205 GTi under development!
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Try doing a datalog with old code and one with new code and see what is different.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".