It seems the wireing for my fan control is causing a backfeed which causes my MS to reset.
At least that's what I'm thinking.
I do have a scope, so where exactly should I scope on the transistor, and if there is some interference, would a cap between the legs of the transistor to ground help?
Thanks.
...Mitch
Fan control a suspect in resets.
Moderators: jsmcortina, muythaibxr
Fan control a suspect in resets.
...Mitch
Turbo'd Bmw M10 engine, 18psi, stock internals.
Using V3 board, with Ms1, HR code.
4 LS-1 Coils, 36-1 VR setup, and 4G15 (optical) Cas Retrofit for 2nd Trigger.
Turbo'd Bmw M10 engine, 18psi, stock internals.
Using V3 board, with Ms1, HR code.
4 LS-1 Coils, 36-1 VR setup, and 4G15 (optical) Cas Retrofit for 2nd Trigger.
-
fritoss007
- Helpful MS/Extra'er
- Posts: 77
- Joined: Fri Jul 29, 2005 5:54 pm
- Location: Sept-Iles, Quebec, Canada
-
jsmcortina
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Did you fit the 1N4001 diode? Either on board to +12v or across the relay terminals.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
fritoss007
- Helpful MS/Extra'er
- Posts: 77
- Joined: Fri Jul 29, 2005 5:54 pm
- Location: Sept-Iles, Quebec, Canada