Hello everyone!
When following the instructions for assembling a V3 board, the output mods for TFI begin at step 65. Where do they pick up again?
Am I correct in believing that I DON'T install the IGBT high current driver circuit?
Also, does anyone know if my 1993 Ford Ranger 2.3 is using the PWM idle valve?
Thanks for your help!
robert
Output Mods for TFI
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 91
- Joined: Thu Aug 25, 2005 9:01 am
- Location: Sardis, British Columbia, Canada
- Contact:
Output Mods for TFI
Supercharged and intercooled 1993 2.3 liter 4 cylinder, 5 speed Ford Ranger.
Adventure for Your Mindhttp://www.newadventure.ca
Supertruck Page
Adventure for Your Mindhttp://www.newadventure.ca
Supertruck Page
-
- Helpful MS/Extra'er
- Posts: 91
- Joined: Thu Aug 25, 2005 9:01 am
- Location: Sardis, British Columbia, Canada
- Contact:
Thank you. I have that information, but I don't know where the main instructions begin again.
robert
robert
Supercharged and intercooled 1993 2.3 liter 4 cylinder, 5 speed Ford Ranger.
Adventure for Your Mindhttp://www.newadventure.ca
Supertruck Page
Adventure for Your Mindhttp://www.newadventure.ca
Supertruck Page