I'm about to build up the daughterboard for MSnSE to do the dual-VR timing and knock. Question is - do i build them onto the same board im making control the TVIS/BOOST/table switching etc or do i build the timing and knock on its own board in case it goes wrong/doesnt work?
Anyone had any further luck with the 1815 circuity on a toyota NE/G1/G2 setup? I'm still trying to decide on the exact input design and im not over confident.
Also, is the tach signal still required if the dizzy signals are available?
Basic board question
Moderators: jsmcortina, muythaibxr