What would the raw number be for 110kpa? For RPM 5=500 34=3400 etc... I think this should be whatever is shown in the datalog right?
I would like to trigger an output at on=12kpa off=110kpa hysterysis=20kpa.
Simple Output 1&2 question
Moderators: jsmcortina, muythaibxr
-
- Experienced MS/Extra'er
- Posts: 348
- Joined: Tue May 04, 2004 3:46 pm
- Location: Illinois, Central
Depends on the map sensor being used. Take a look at the kpafactor.inc file in your mtCfg folder. Look up the desired kPa value, and read off the ADC value.
Roger.
Roger.
1979 Mazda RX-7, running MSnSExtra hi-res 09c for fuel and spark control on a turbocharged, intercooled, and (of course!) injected 13B rotary.
-
- Experienced MS/Extra'er
- Posts: 348
- Joined: Tue May 04, 2004 3:46 pm
- Location: Illinois, Central