I have a VR dizzy currently firing the coil itself with a 4 pin bosch module. Ms gets its tach signal from the coil -. The module does not look like the one on the extra pages. It is a small rectangle with all 4 pins coming out along one of its lengths.
What i was wondering is if i lock the dizzy down can i connect the coutput of the module to ms (but not to the coil -), and use that as my tach signal? Is it likely to damage the module or ms? Then i would be using a VB921 to fire the coil..
Thanks
andrew
Bosh 4 pin to condition VR signal
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
I don't see why this wouldn't work, same as the old HEI4 conditioner setup. You'll need a pullup resistor on the tach input.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".