Hello there
i was going to use EDIS, but due to certain limits (spark cut for one) i would like to use wheel decoder.
I've done a search, but info is sketchy. I would like to know what hardware mods are required on the V3 board - which i have yet to order.
I will be using a 36-1 wheel wih an inductive pickup. Do i need a conditioning circuit for this, or is it std in V3. What about ignition drivers? COP (with cam sensor) would be nice, but for now i want wasted spark ie two igntion outputs.
Many thanks
Wheel Decoder
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Check out the board picture shown on http://megasquirt.sourceforge.net/extra which lists the usage of the various pins on the chip.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".