MS-I, pcb v3, dizzy hall setup, wanting to run spark
I have everything included/removed/jumped as per the msns-e directions, but on the codebase and output functions page do I need to set spark output A on Fidle or on LED17?
I have :
on the bottom
IGN to IGBTOUT jumped
IGBTIN to inline 330 resistor to top of r26
I have r57 removed
jumpers on D1 and D2
C12 and C30 not installed
R43 jumped
Hall sensor setup:
Pullup from S12 to TACHSELECT
TACHSELECT to OPTIONIN
OPTIONOUT to TSEL
and XG1 to XG2
Thanks
ALex
MS-I, PBC 3 questions
Moderators: jsmcortina, muythaibxr