Hi,
I noticed in my logs that my engine status code would always go from 0 to 3 (cranking & running) then to 13 (running, ASE & WUE) then 1.
The code 13 would only last ~2.5 seconds but I never see the engine running and WUE only. It doesn't seem normal to me because a) I set my ASE to be 60 seconds (not cycles), and b) why don't I see a code of 5 (though Gwarm in the log seems to reflect the correct WUE units).
For background - I'm using MS-I v3 board, 29q2 code.
thanks.
Should I see both ASE and WUE in my log?
Moderators: jsmcortina, muythaibxr
Thanks itguy... looked at your thread and I'm having same strange behaviour.
Have started a new thread asking if this could be a 29q2 bug. See here: http://www.msefi.com/viewtopic.php?t=21470
Though nobody seems to know/care?
Have started a new thread asking if this could be a 29q2 bug. See here: http://www.msefi.com/viewtopic.php?t=21470
Though nobody seems to know/care?