Toothed wheel pick up

terrastudios · Post by **terrastudios** » Sat Aug 12, 2006 2:16 pm

Hi all,

I have a renault-based engine and the flywheel arrangement is as the attached picture - does the MSns-E code support this arrangement currently?

Basically the reason why I am confused is the larger "two-teeth-joined-together" typed situation, and how to configure MSnS-E to support this arrangement.

Many thanks in advance

Matt.

Post by **jsmcortina** » Sun Aug 13, 2006 4:08 am

This was discussed just a few weeks back and I am fairly sure the answer was no.

James

terrastudios · Post by **terrastudios** » Sun Aug 13, 2006 11:27 am

jsmcortina wrote:This was discussed just a few weeks back and I am fairly sure the answer was no.

James

Hmmmmm thats unfortunate, is there any easy method of doing a pick up - the engines assembled in the car, so i don't fancy removing gearbox etc.. to change to a different flywheel!

Many thanks in advance

Matt.

oopsmotorsport · Post by **oopsmotorsport** » Mon Aug 14, 2006 3:57 pm

i have used a signal wheel on the front pully with a ford sensor seems to work ok