a "no idle control valve" question

65looter · Post by **65looter** » Sat Aug 12, 2006 2:57 pm

I do not have an idle control valve installed, could someone tell me where could i find the setting in megatune to make sure the system is not trying to look for one?

cheers

PSIG · Post by **PSIG** » Sat Aug 12, 2006 8:28 pm

65looter - If you're not using the FIdle output for idle or spark, just ignore the settings, which are in MegaTune under Basic Settings/Engine constants and /Codebase & outputs.

David

65looter · Post by **65looter** » Sun Aug 13, 2006 12:57 am

I have for the outputs:
FIDLE Idle control
LED17 SparkA

can i then swap for:
FIDLE SparkA
LED17 Squirt

thanks for your time, much appreciated.

PSIG · Post by **PSIG** » Sun Aug 13, 2006 9:31 am

Yes, if you are wired to use those outputs in that manner.

David

65looter · Post by **65looter** » Sun Aug 13, 2006 2:41 pm

I don't think Phil wired them that way.
If I swap for
FIDLE SparkA
LED17 Squirt

when I start the car, it's like there is a short somewhere, turn off the engine, and the starter kicks back...etc..

I guess I am stuck with the
IIDLE Idle control
LED17 SparkA