MSnS-E
MS1 chip on V3 mainboard.
MSD 6A
Everything tested and works perfect.
I run jumper From IGN to (-) of D14 on mainboard like on this picture: http://megasquirt.sourceforge.net/extra ... msdbox.gif
There is a stable ground on pin 36 then spark pulse. I think MS works fine.
Everytime then I ground white wire from MSD I got spark - I think MSD works fine.
After that I connect white wire from MSD to 36 pin and got +12 from MSD and oly +2.5V then spark puilse and there is no sparks...
Solution - 0.02 Ohm resistor from pin 36 to the ground can lower 12-2.5V to 10-0V, but i don't thing that Q6 pass through 600 mA and not burn.
That can I do to solve this trouble?
(sorry for my terrible english).
MSnS-E and MSD 6A ignition trouble.
Moderators: jsmcortina, muythaibxr
