I have built the active high table switching circuit per the MSnSe site instructions (http://megasquirt.sourceforge.net/extra ... witch.html)
But what I'm finding is: when I apply +12V to the base of the 2N2222, I'm seeing 1.8V at the output instead of ~0V so MS never sees a low.
Any idea? Any tried this circuit?
thanks.
Dual table hardware problem / question
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Check that you installed the transistor correctly. I am using this circuit as part of the nitrous control and it works for me.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".