Flashing FP -read FAQ, Dont understand the Mini Terminal

Miles965uk · Post by **Miles965uk** » Sun Aug 27, 2006 11:32 am

I have V3 MS1 with 029s, using 1 spark output for the orignal dizzy.

Everything was running fine on my 911 but one day the MT didnt load up so I went to download 029s and now I get a flashing fuel pump error, when I turn it off and back on again. I went to the mini terminal as in the FAQ and it says I cannot have more than 1 spark output defined.

In the outputs all I have is 1 output, if I switched of the MSnS , its fine I have played around with the outputs to see if there is any change but no luck. I have copied my outputs.

Please help, I have tried reinstalling the .s19 file also.

Thanks!

Morten VJ · Post by **Morten VJ** » Sun Aug 27, 2006 11:57 am

The weel decoder is set to generic WEEL.
Try setting it to OFF

Miles965uk · Post by **Miles965uk** » Sun Aug 27, 2006 12:37 pm

Hi thanks
Ok I will try and get back but am using a 60-2 for the trigger input...

Morten VJ · Post by **Morten VJ** » Sun Aug 27, 2006 1:03 pm

Then turn Msns off.
You can't run both, as inputs.

Morten

Miles965uk · Post by **Miles965uk** » Sun Aug 27, 2006 3:12 pm

Ok I see!
Tried it and it works ok with the MSnS to off.
I was thinking of the old MSnS routine...
Thank you very much