Hello,
V3 board with MSNS-e firmware 029q. The warm up LED (15) is permanently on, regardless of what i do with the stimulator board.
Everything else works fine.
I'm getting a 5 volt feed from pin 9 on the processor. No solder shorts on the board, and it is as clean as a whistle- no flux residue.
Any ideas, anyone else had this problem?
Andy
LED 15 warm up light remaining on.
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 54
- Joined: Wed Oct 19, 2005 9:43 am
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
On the Codebase & Outputs page what do you have LED18 (D15) set to? Is it set to warmup?
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Helpful MS/Extra'er
- Posts: 54
- Joined: Wed Oct 19, 2005 9:43 am