LED 15 warm up light remaining on.

the bubbler · Post by **the bubbler** » Sun Sep 03, 2006 11:40 am

Hello,

V3 board with MSNS-e firmware 029q. The warm up LED (15) is permanently on, regardless of what i do with the stimulator board.

Everything else works fine.

I'm getting a 5 volt feed from pin 9 on the processor. No solder shorts on the board, and it is as clean as a whistle- no flux residue.

Any ideas, anyone else had this problem?

Andy

Post by **jsmcortina** » Sun Sep 03, 2006 11:54 am

On the Codebase & Outputs page what do you have LED18 (D15) set to? Is it set to warmup?

James

the bubbler · Post by **the bubbler** » Sun Sep 03, 2006 12:06 pm

Ah that was it.

It was set to IRQ trigger.

Thank you very much, still getting my head around all the different features.

Andy