Hi all! I'm running a MS1/PCB3.0 on my boosted Honda CRX. I'm using 029y4 firmware.
Some days ago I've noticed some misfires and glitches when boosting (~12/15 psi). When running on low MAP loads everything is fine, so yesterday's night I've logged a bit and then...
As you can see, suddenly duty cycle goes near 0 without any reason, is this a noisy condition?
This is my current tune and my last log
Today I'm going to do some cable management and improves to my Megasquirt.
Thanks in advice,
Possible noise condition?
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: Possible noise condition?
Duty cycle going to zero generally indicates a fuel cut of some sort, such as a rev limiter.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
-
- Super MS/Extra'er
- Posts: 1986
- Joined: Sat Jul 22, 2006 8:02 pm
- Location: Eureka, NV USA
- Contact:
Re: Possible noise condition?
Yep..... Dropping to zero at ~7400 rpm.... right where he has it set in his msq!Matt Cramer wrote:Duty cycle going to zero generally indicates a fuel cut of some sort, such as a rev limiter.
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
-
- Helpful MS/Extra'er
- Posts: 76
- Joined: Sun Jun 02, 2013 8:14 am
- Location: Buenos Aires, Argentina
- Contact:
Re: Possible noise condition?
Oh, I'm a fool.
Sorry about that, btw I know I have that misfires so I'll keep testing.
Sorry about that, btw I know I have that misfires so I'll keep testing.
-
- Helpful MS/Extra'er
- Posts: 76
- Joined: Sun Jun 02, 2013 8:14 am
- Location: Buenos Aires, Argentina
- Contact:
Re: Possible noise condition?
Hi everybody! Following with my noisy problems, I've tested other Megasquirt I was building for a friend, so I've loaded my MSQ, then cranking and it runs very well!
I've made some pulls and everything work'd fine, so I plugged in my Megasquirt again, and everything works fine again!! So, my problem is around my messy wiring installation.
I've made some pulls and everything work'd fine, so I plugged in my Megasquirt again, and everything works fine again!! So, my problem is around my messy wiring installation.