MS1, 3,57 BOARD, MODIFIED FOR 2 COIL OUPUTS, MAP-DADDY BARO.
I've pulled this off the shelf after a few years to finally start the install. I'm trying to do initial bench test to make sure everything is ok, when I connect with tuner studio, I get a configuration error. I can't seem to figure out where it is. I'm using the megastim and I seem to remember the last time I had this hooked up, if I had it set on generic wheel mode, I'd get an error. I can't seem to get it to reset to back to a state that will allow for testing.
Any help would be appreciated.
Basic Configuration Error - Stim Based?
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39585
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Basic Configuration Error - Stim Based?
What is the config error message?
Please upload your MSQ as an attachment. (See the Forum help page.)
James
Please upload your MSQ as an attachment. (See the Forum help page.)
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: Basic Configuration Error - Stim Based?
OK. Here is the MSQ.
I can't get it to display the specific error. I will try it a few more times.
I can't get it to display the specific error. I will try it a few more times.