Building ms1 v2.2 no tps signal passes but troubleshooting
Moderators: jsmcortina, muythaibxr
-
- MS/Extra Newbie
- Posts: 3
- Joined: Fri Sep 15, 2017 10:36 am
Building ms1 v2.2 no tps signal passes but troubleshooting
I'm having a dilemma of whether to move on to the output section or not because I'm testing my ms1 on megatune but the tps isn't working. How do I know if it's the stimulator or my ms1 before moving on.
-
- MS/Extra Newbie
- Posts: 3
- Joined: Fri Sep 15, 2017 10:36 am
Re: Building ms1 v2.2 no tps signal passes but troubleshooti
Could this be moved to the Boards forum. It's get some more traction there. I'm new here and eager to get this thing finished before I start the motor swap
Re: Building ms1 v2.2 no tps signal passes but troubleshooti
Check the voltage to ground with a DVM at the TPS input pin on the DB37. It should vary as you alter the stim pot.erikfromgilroy wrote:I'm having a dilemma of whether to move on to the output section or not because I'm testing my ms1 on megatune but the tps isn't working. How do I know if it's the stimulator or my ms1 before moving on.
BTW, best to use TunerStudio these days.
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
MS2 V3
EDIS
Tech Edge O2
London UK.
-
- MS/Extra Newbie
- Posts: 3
- Joined: Fri Sep 15, 2017 10:36 am
Re: Building ms1 v2.2 no tps signal passes but troubleshooti
New update. I did some stuff for Edis to work on my ms1 and now it won’t connect to tunerstudio. I did exactly the hardware mods listed on DIYAutoTune ms 1 v2.2 board and now no connection.