The traces handles at least 5 amperes per trace,they are 2.0mm wide.
There are 25 solder points with 3mm diameter pads, with 1mm holes.
The wiring loom from Megasquirt can be soldered in there.
The 25 pin connector is used by Bosch EZK 116K boxes and Digifant ECU's.
They accept maximum 18 AWG gauge, thats a wire with 1.024mm Conductor diameter.
Grundplanes for thermic relief are also on the PCB.
Sorry for the low picture quality.
Digifant/EZK 25 pin adapter board
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 147
- Joined: Tue Oct 27, 2009 3:49 pm
- Location: Norway
-
- Helpful MS/Extra'er
- Posts: 147
- Joined: Tue Oct 27, 2009 3:49 pm
- Location: Norway
Re: Digifant/EZK 25 pin adapter board
The Prototype PCB's was ordered today.
Re: Digifant/EZK 25 pin adapter board
Hi,
Any progress on this?
Thanks.
Jon.
Any progress on this?
Thanks.
Jon.