Digifant/EZK 25 pin adapter board

A forum for discussing the MegaSquirt related (but non-B&G) board development, assembly, installation, and testing.

Moderators: jsmcortina, muythaibxr

Post Reply
357supermagnum
Helpful MS/Extra'er
Posts: 147
Joined: Tue Oct 27, 2009 3:49 pm
Location: Norway

Digifant/EZK 25 pin adapter board

Post by 357supermagnum »

The traces handles at least 5 amperes per trace,they are 2.0mm wide.
There are 25 solder points with 3mm diameter pads, with 1mm holes.
The wiring loom from Megasquirt can be soldered in there.
The 25 pin connector is used by Bosch EZK 116K boxes and Digifant ECU's.
They accept maximum 18 AWG gauge, thats a wire with 1.024mm Conductor diameter.
Grundplanes for thermic relief are also on the PCB.
Image
Sorry for the low picture quality.
357supermagnum
Helpful MS/Extra'er
Posts: 147
Joined: Tue Oct 27, 2009 3:49 pm
Location: Norway

Re: Digifant/EZK 25 pin adapter board

Post by 357supermagnum »

The Prototype PCB's was ordered today.
jaybe
MS/Extra Newbie
Posts: 1
Joined: Thu May 25, 2017 6:46 pm

Re: Digifant/EZK 25 pin adapter board

Post by jaybe »

Hi,

Any progress on this?

Thanks.
Jon.
Post Reply