I have two designs ready to roll, but before I have a bunch made, it would make sense to ensure the boards *fit*!
I'm looking for someone willing to open their box and dry-fit bare examples of two PCBs. The appropriate mounting hardware will be included. The whole process, once the box is open, should take all of 10 minutes.
Anyone interested in helping?
Tester wanted - V3.57 board
Moderators: jsmcortina, muythaibxr
Tester wanted - V3.57 board
Temporarily shut down - back soon!
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
-
- Experienced MS/Extra'er
- Posts: 201
- Joined: Thu Jan 23, 2014 4:29 pm
- Location: Worcester Ma.
Re: Tester wanted - V3.57 board
I have my box out of the car quite often. I'm a little far away though
87 Turbocoupe 351w swap with a TKO, someday a turbo car again.
MS2 3.0 3.4.0
MS2 3.0 3.4.0
Re: Tester wanted - V3.57 board
The wonder that is the post office ... If that Ma. in your location is Massachusetts, you're a lot closer than the fellow from South Africa!
Temporarily shut down - back soon!
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems