I'm doing it wrong.
Is there a link to a step-by-step CAN configuration setup? (for MS2 and MShift GPIO)
Every time I try to set it up I get errors, and not always the same one either. Then I remove the CAN device and it all goes back to normal. Obviously I'm missing a step somewhere.
Jim
CAN configuration
Moderators: jsmcortina, muythaibxr
-
Jim_Blackwood
- Helpful MS/Extra'er
- Posts: 127
- Joined: Mon May 06, 2013 9:54 am
- Location: Greater Cincinnati