QuadraMap cam signal question

A forum for discussing the MegaSquirt related (but non-B&G) board development, assembly, installation, and testing.

Moderators: jsmcortina, muythaibxr

Post Reply
lutorm
Helpful MS/Extra'er
Posts: 146
Joined: Sat Apr 11, 2015 2:53 pm
Location: The island of Hawaii

QuadraMap cam signal question

Post by lutorm »

I'm working to get phase detection with the QuadraMap "cam signal" working, and after scoping the signal I just wanted to make sure I'm not mistaken: The cam signal is an edge detection signal, ie it makes a short high pulse when the #1 MAP drops below the set threshold, and not a comparator output, ie being high for the duration the #1 MAP is below the threshold? The wording had led me to believe the latter but the scope output shows pretty clearly it's the former.

Cheers,

/Patrik
dontz125
Super MS/Extra'er
Posts: 4200
Joined: Mon May 11, 2009 7:14 pm
Location: York, ON
Contact:

Re: QuadraMap cam signal question

Post by dontz125 »

It's a pulse.
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
Post Reply