Using IRLZ44 to drive injectors

A forum for discussing the MegaSquirt related (but non-B&G) board development, assembly, installation, and testing.

Moderators: jsmcortina, muythaibxr

Post Reply
TheRipper
MS/Extra Newbie
Posts: 13
Joined: Wed Nov 21, 2007 4:11 pm
Location: Rio de Janeiro, Brazil

Using IRLZ44 to drive injectors

Post by TheRipper »

Hi!

I'm trying to build a circuit to drive four injectors for full sequential on a MS2 V3. The ideia was to replicate the V3 inj. driver circuit for the other two injectors, but I was told that I can replace the whole circuit with just a IRLZ44 (a logic level driver) and a 390 Ohms resistor for each injector! Is that right?

Thanks!
Post Reply