Bosch on-board MAP sensor (1267632015) voltage vs. pressure?

[B1ack_Mi16]

Can anyone help me out with voltage vs. pressure on this map sensor?

It was located inside the ECU box soldered directly to the board.

[LAV1000]

maybe this (200kPa) one:
http://www.farnell.com/datasheets/49036.pdf

[B1ack_Mi16]

Not sure, I found that pdf the other day too, but part numbers are at not matching, so not sure.

[LAV1000]

Most Bosch partnr's start with a 0.
The number youre revering to could be the part number from a car manufacturer.

Live would be much easier and cheaper if they all used the same number for identical parts

[B1ack_Mi16]

Ok. The other file linked to was for 250 and 300kPa sensors.

I found this today (http://datasheet.seekic.com/datasheet/0273003204.html#), which have the curves for 105kPa and 200kPa sensors.
Just for reference.

What I found in the end is the following:

-------------------------
Trykksensor 105 kPa
273003203

Spenning Trykk
[V] [kPa]
0 12.45
0.4 20.00
4.9 105.00
5 106.89
-------------------------


-------------------------
Trykksensor 200 kPa
273003204

Spenning Trykk
[V] [kPa]
0 10.13
0.25 20.02
4.8 200.02
5 207.93
-------------------------

-------------------------
Trykksensor 250 kPa
273003210

Spenning Trykk
[V] [kPa]
0 10.00
0.2 20.00
4.8 250.00
5 260.00
-------------------------

-------------------------
Trykksensor 300 kPa
273003211

Spenning Trykk
[V] [kPa]
0 -6.36
0.4 20.00
4.65 300.00
5 323.05
-------------------------