Microsquirt and Wiring Ford 20uF Noise Capacitor

[oscarmax]

I have managed to purchase a brand new old stock Ford Noise Suppression Capacitor 89AB12A19AA with James Murray's help. My set up is Microsquirt V3 and ford EDIS4, I realise the capacitor need to goes as close as possible to the coil pack and the feed from the module, however, I am a little confused about the final connections of the noise capacitor.

[jsmcortina]

The factory plug has one wire that connects to 12V by the coil. The capacitor grounds through the bolt.

I'll see if I can get at my wiring later on to figure out which pin it is.

James

[grom_e30]

[DaveEFI]

Wonder if it's a 'feed through' type? They used to be the definitive suppressors. Used on military vehicles with radio comms.

[oscarmax]

Out of curiosity what is the function of the other terminal ?

[oscarmax]

Wonder if it's a 'feed through' type? They used to be the definitive suppressors. Used on military vehicles with radio comms.

I notice you are using a Techedge o2, that is my next step in the new year 2J9

[grom_e30]

im not sure but the 2 pins have continuity to each other, and they both measure the same capacitance reading from pin to ground.

[kjones6039]

im not sure but the 2 pins have continuity to each other, and they both measure the same capacitance reading from pin to ground.

Your description certainly sounds like a feed thru to me.........

Ken