I'm working on a Ford 351W running MS2.
I'm going to run EDIS and want to get a Cam Position sensor to turn the oil pump after removing the Distributor.
I'd like to prepare for the possibility of going sequential with MS3 in the future.
Which Cam sensor do I want? The one with the half moon or single tooth? 3 wire or 2?
I understand that I should be using the half moon style which is 3 wire Hall effect. Is that correct?
I'm adapting a 3.8l shaft to use with a 351w base, and have a choice of 3.8l sensors to use.
Thanks
Don
Sent from my iPhone using Tapatalk
Hall or VR Cam position sensor
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 6828
- Joined: Sun May 15, 2011 11:41 am
- Location: Walnut Creek, Calif. USA
Re: Hall or VR Cam position sensor
Half-moon and Hall is what I use and recommend.
Re: Hall or VR Cam position sensor
Thank you
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Hall or VR Cam position sensor
If making your cam sensor for an old dizzy (on my engine it also drives the oil pump) you can use a cheap and small Allegro gear tooth hall sensor.
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
MS2 V3
EDIS
Tech Edge O2
London UK.