Has the signature PIP (v8) been put into the code? I read a couple posts where you had plain old TFI done, but were (possibly) working on the signature signal type.
If code is there, has anyone tested it?
Have a Ford with MS2 2.6 code that I would like to try MS2-E on, but I do not want to be alpha tester. A freshly converted carbureted car and being alpha tester is asking for trouble!
TFI Ignition Signature PIP
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
TFI can be used the same as a regular dizzy by triggering off a single edge.
The signature PIP might be adding too much complexity as the hall sensor apparently triggers differently depending on temperature ?!
James
The signature PIP might be adding too much complexity as the hall sensor apparently triggers differently depending on temperature ?!
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Well I didnt see it in the ignition options, and I thought you were going to at some point possibly do both edge trigger instead of just simple and rising edge.
I will try rising edge and let you know what happens.
p.s. I know I always spell wheather wrong wheather or not the outside weather. Sorry for being silly, it is the little, red, happy sinus meds.
I will try rising edge and let you know what happens.
p.s. I know I always spell wheather wrong wheather or not the outside weather. Sorry for being silly, it is the little, red, happy sinus meds.
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
The reason for probably abandoning the both edges is because due to a Ford document the hall sensor responds differently depending on the temperature. Without some correction in there this would impact timing accuracy.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".