andyducati wrote:Hi all,
I have just uploaded this new firmware to my MSII and every time i power up the MS i get a Settings Configuration error.
The reported setting error is "INVALID MAP SAMPLING ANGLES. NEEDS TO BE LESS THAN 180 DEG FOR 4CYL OR 90DEG FOR V8"
Andy
General/lags. Try "average" instead, then remap.
If you want to use the normal/old code, I ran 5 degree sample time, going too long just gives you a poor average.
The new averaging code takes many more samples and averages them, worked out much better for me with a remap and some massaging.
Using the timed sampling, I got some HUGE MAP swings over the RPM range. (I adapted, but ...)
Basically I set it for best signal at idle/low RPM.
MS3 has a table so the angle can be changed over the RPM range, MS2 is a fixed angle.
I'd now set it to "average" and retune the VE table as needed.
Always doing things the hard way, MS2 sequential w/ v1.01 mainboard, LS2 coils. 80 mile/day commuter status.