Hello,
I was playing with CAN this afternoon => checking DBC vs real world.
My setup : MS2 extra 3.4.1 / CAN broadcasting PDF / BusMaster
i.e : Looking at signal "sensor9" (adc6 for MS2). Document state for "multiply = 1 / Divide = 10" to interpret this signal. But when I sniff it it look like it's a RAW signal. So divide 10 result in 24 when ADC is 240.
Any thoughts ?
Also, for MS2 AFR is afr1_old which is deprecated in MS3. Is there a chance that this will change in the future ?
Best regards,
Manu
CAN interpretation
Moderators: jsmcortina, muythaibxr