CAN to 3rd party ECU

This is a forum for discussing the development and testing of alpha MS2/Extra code. Documentation
(Runs on MS2 and Microsquirt)

Moderators: jsmcortina, muythaibxr

Post Reply
Frankzz
MS/Extra Newbie
Posts: 4
Joined: Wed Apr 19, 2017 4:40 am

CAN to 3rd party ECU

Post by Frankzz »

I know this is one of those "if you have to ask, you cant do it". But I will try anyway.
Has anyone tweeked the CAN in a microsquirt so the CAN works with a 3rd party ECU? Change CAN in Microsquirt to work with 3rd party device? I know it works to send to data loggers and dash but I need to get data to the Microsquirt. I think I saw a post on this when looking for something else but cant find it again.
I have the what is needed for the ECU and have help from experienced friends but and help is appropriated
Volvo Amazon -69. T5 with AW30-43, Chopped and widen in the middle. Citroen suspension
Range Rover -78 with BMW M67 V8 twin turbo diesel
Jeep -61 with Wrangler -06 body. D5 with 30-43, Toyota transfer case and portal axles
Volvo B 58 -79 bus. 14,5 meter party bus with garage in the rear
jsmcortina
Site Admin
Posts: 39585
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:

Re: CAN to 3rd party ECU

Post by jsmcortina »

I'm not sure what you are asking here. Are you trying to send or receive or what?

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Post Reply