FORD TFI CCD control

This is a forum for discussing the development and testing of alpha MS2/Extra code. Documentation
(Runs on MS2 and Microsquirt)

Moderators: jsmcortina, muythaibxr

FORD TFI CCD control

Postby ogimieras » Tue Nov 14, 2017 12:47 am

Hello,

I have MS2 V3.0
In hardware manual there is writen to use BIP373 driver to control Ford TFI ignition module.

Can i control this TFI module direct from procesor, and ignore high current ignition driver circuit. Becouse TFI module already have high current ignition driver inside.
ogimieras
MS/Extra Newbie
 
Posts: 2
Joined: Tue Nov 14, 2017 12:33 am

Re: FORD TFI CCD control

Postby Matt Cramer » Tue Nov 14, 2017 7:40 am

You will need some sort of circuit that generates a 0-12 volt square wave. Processor output pins have a maximum voltage of 5 volts.
Matt Cramer
Super MS/Extra'er
 
Posts: 13736
Joined: Thu Apr 16, 2009 8:08 pm

Re: FORD TFI CCD control

Postby ogimieras » Mon Nov 20, 2017 11:17 am

Thank you for explain.
ogimieras
MS/Extra Newbie
 
Posts: 2
Joined: Tue Nov 14, 2017 12:33 am


Return to MS2/Extra Development

Who is online

Users browsing this forum: No registered users and 1 guest