36-2-2-2 on Subaru - Any update for COP?

This is a forum for discussing the development and testing of alpha MS2/Extra code. Documentation
(Runs on MS2 and Microsquirt)

Moderators: jsmcortina, muythaibxr

36-2-2-2 on Subaru - Any update for COP?

Postby phoenix3d » Wed Nov 15, 2017 1:00 am

Hi All..

Just would like o inquire as to any update to the 36-2-2-2 wheel mode when used on Subaru (4cyl) COP.
Has there been any work to support the COP full sequential abilities of the code?

if not what is required to complete this? i see in the source it notes that 4 Cyl COP is not supported due to the CAM signal..
Could you clarify? I am aware that the CAM signal is a 2 pip wheel and I have a Datalog for use if required.

This would be a Super beneficial update for the Scooby Users out there.

Kindest Regards
Gordon.
phoenix3d
Experienced MS/Extra'er
 
Posts: 176
Joined: Wed Mar 19, 2008 2:12 pm
Location: South Africa

Re: 36-2-2-2 on Subaru - Any update for COP?

Postby jsmcortina » Wed Nov 15, 2017 3:50 am

MS2/Extra is now in mature state. If bugs are found, we'll try to fix them, but there are no plans for new features.

36-2-2-2 COP has been supported on MS3 for a long while.

James
I can supply, repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: viewtopic.php?f=104&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
jsmcortina
Site Admin
 
Posts: 34073
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK


Return to MS2/Extra Development

Who is online

Users browsing this forum: No registered users and 2 guests