Idle air control

A general forum and a place for initial or prospective users. See Manuals/Documentation
Click here to enter
Contact a Forum Administrator
If unsure where to post, post in this sub-forum.

Moderators: jsmcortina, muythaibxr

Post Reply
jonfx4com
Experienced MS/Extra'er
Posts: 282
Joined: Fri Nov 18, 2005 8:30 am
Location: North of UK
Contact:

Idle air control

Post by jonfx4com »

I'm am using a stepper IAC for idle air and want to run my setup by anyone who can comment.

I have tapped into each of my ITB's just in front of the injectors and installed 8MM (slightly over 1/4") take offs. I have piped these all to a foot long "plenum tube" of diameter 1" and my IAC valve regulates air into the tube. I am concerned that this may be allowing one cylinder to pull mixture from another at idle. Am I going the right way with this setup, all comments would be appreciated.

Jon
Post Reply