VR sensor in 3TC distributor

CHB · Post by **CHB** » Fri Jun 09, 2006 3:31 am

there are 2 wires from the VR sensor in my 3TC distributor, one is red and another one is white.
which one is positive and which one is negative?
does any one run a 3T turbo on Megasquirt II?

238ur50 · Post by **238ur50** » Fri Jun 09, 2006 5:43 am

i would think your red wire is power and the white is ground

you can hook them up and if they don't work one way switch it, you won't hurt anything

i can also take a look at my buddy's 3tc motor today and try to figure out which red is what

CHB · Post by **CHB** » Mon Jun 12, 2006 9:03 pm

thanks for the information. is ur buddy running a 3TC MS II too? may be u can share the ignition table if u don't mind?

238ur50 · Post by **238ur50** » Tue Jun 13, 2006 10:30 am

no he is not, he is running a Haltec, b/c his buddy runs it so he has to run it, i tryed to talk him into a MS but he won't listen to me, but now him and his buddy 1000miles away can't get it to run right and i am like i don't s*** about that high dollar stuff ;)

i could make you an table but it will need to be dyno tuned or ran at the track to get the timing perfect to find that perfect spot

richie

CHB · Post by **CHB** » Wed Jun 14, 2006 1:55 am

thanks mate!! mine 3TC specs as follow
63cc stock head.
8.0 CR(estimated)
86mm pistons.
looking forward about the ignition map