Posted: Wed Jul 12, 2006 1:26 pm Post subject: IAC Control
--------------------------------------------------------------------------------
Hi,
Just a bit of help fault finding a non functionate Stepper. The item below (apologies for crap picture, only mobile handy at the time) came off a Rover V8, not sure of make but has following markings:
704409
B1884
Basically it seems to be always fully retracted i.e it lets air into the manifold constantly.
I've fiddled with the start position is MS to no avail, coil A and coil B both measure 58 Ohms which would seem to be correct, connected to 25, 27 29, 31.
Have I missed something on building the MS board
Using MS II V3 Board with MT 2.25 code 2.36
Any help appreciated.
Thanks
Darren
IAC Control
Moderators: jsmcortina, muythaibxr