Hello,
We are currently running the following:
MicroSquirt:http://www.diyautotune.com/catalog/micr ... p-519.html
Tunerstudio MS v2.6.14
Firmware: MS2/Extra release 3.3.3
We are not getting any RPM readings in TunerStudio, I hooked up an oscilloscope and we are getting the right signals from VRIN(18 teeth, 1 missing) can be seen (I can upload an image if needed...).
I tried adding a 10K resistor but that did not help get any readings, I have been looking through previous forum posts but cannot find anything...
Any ideas or thoughts? I can add more info if needed.
Thanks ahead!
MicroSquirt RPM Readings
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39585
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: MicroSquirt RPM Readings
Have you tried taking a tooth log? (This is covered in the Megasquirt2 Setting Up manual)
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".