MS3 board Jumpering for GM DIS or Not?

[BossHoggett]

Hi all,
Before i leap out and buy a MS3 i'm still getting my head around the issue of what to buy.
I want to run a Chevy /Buick V6 (its a Holden 3800 in Australia) which has Cam and Crank sensors.

Do i need to buy a base MS3 and a jumper kit or something extra?
and if so is there a wiring diagram available for it?

Any other suggestions available to make the correct purchase first time, preferably id like to buy a complete computer to minimize the dramas i may have with installation for my first time.
Thanks

[Matt Cramer]

You could use a base MS3 setup and have ignition control with bank to bank fueling, but adding an MS3X will give you sequential injection and a lot more I/O. I'd go the MS3X route.