Hi Guys,
This is my first ever forum post Been struggling for a few weeks to get my car started and I suspect I have a random spark signal but am not 100% Need some advice from the team
Car wont actually start. Sounds like it wants to go but just wont quite go. I appear to be getting intermittent spart on my timing light and when the timing light flashes it is on the correct timing mark and is also when I hear the engine fire.
Here's what I have;
MS1 with 029y4a firmware loaded
12a Bridgeport
4 x 550cc injectors (the oval plug ones from a series 5 turbo RX7)
4 x IGN-1A for spark
Wires that go to pin A (signal) on the coils are.... The thick red one goes to both leading and the other two go to the trailing coil signals respectively.
Can someone please confirm I have all this correct?
Currently I have only connected the leading plug leads as I think it should start and run fine on those and then once running I will confirm the trailing firing order and connect those up. (if only I could get it running)
Any help is greatly appreciated.
Kind regards
Steve
MS1 Spark Issue on Mazda Rotary
Moderators: jsmcortina, muythaibxr
MS1 Spark Issue on Mazda Rotary
Last edited by Mazda808 on Sun Jul 24, 2016 8:13 pm, edited 1 time in total.
Re: MS1 Spark Issue on Mazda Rotary
Sorry guys, here is the MSQ and a recent data log.
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: MS1 Spark Issue on Mazda Rotary
Normally I'd use the circuit with pull ups instead of inline resistors. Use a 330 ohm pull up resistor. When using pull ups and triggering off the negative terminal of the LED, set spark output inverted to No.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: MS1 Spark Issue on Mazda Rotary
Thanks heaps for the reply, is there a wiring diagram somewhere for that, I've had a look and can't seem to find it?
I just want to make sure I don't mess it up
I just want to make sure I don't mess it up
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: MS1 Spark Issue on Mazda Rotary
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: MS1 Spark Issue on Mazda Rotary
Awesome! Thanks heaps!
Sent from my HTC_0P6B using Tapatalk
Sent from my HTC_0P6B using Tapatalk