Looking for BASIC ecu for a big block ford
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 6828
- Joined: Sun May 15, 2011 11:41 am
- Location: Walnut Creek, Calif. USA
Re: Looking for BASIC ecu for a big block ford
Yes, you can run those injectors and a single coil from the mainboard, no necessity of the MS3X for now.
-
- Super MS/Extra'er
- Posts: 1978
- Joined: Wed Apr 15, 2009 11:31 am
- Location: Oxford, PA
- Contact:
Re: Looking for BASIC ecu for a big block ford
Do you have resistance specs on the Moran injectors? I doubt the mainboard drivers could drive 16 but 8 possibly.
Yes you only need 3x if you want seq fuel, multiple ign, and any of the other things (nitrous, launch, etc) without building those circuits. Almost all are possible to diy its just easier once you get to a few extras to do the 3x.
Yes you only need 3x if you want seq fuel, multiple ign, and any of the other things (nitrous, launch, etc) without building those circuits. Almost all are possible to diy its just easier once you get to a few extras to do the 3x.