Weatherpack/Metripack Info

A general forum and a place for initial or prospective users. See Manuals/Documentation
Click here to enter
Contact a Forum Administrator
If unsure where to post, post in this sub-forum.

Moderators: jsmcortina, muythaibxr

Post Reply
Raymond_B
Super MS/Extra'er
Posts: 1394
Joined: Thu Mar 06, 2014 2:17 pm
Location: Texas
Contact:

Weatherpack/Metripack Info

Post by Raymond_B »

I am sure to some of you guys this is obvious and known information, but it was not immediately obvious to me when I first started wiring up my project. I was just going by wire gauge, but that can be a bit deceiving for Weatherpack and Metripack so I though I would share.

This site puts it all in an easy read.

http://www.whiteproducts.com/faqs.shtml

http://www.whiteproducts.com/metripack-faqs.shtml

Delphi's site https://www.delphi.com/manufacturers/cv ... connectors

Main PDF for Metri-Pack http://ecat.delphi.com/docs/default-sou ... r&sfvrsn=0

Glad I caught that as I was going to use too small of a Metripack for my IGN-1A coils. Now I am using Metripack 630 series for grounds and power, same for my fuel pump and cooling fans.
1995 Ford Lightning. Dart based 427 Windsor, Novi 2000, full sequential, E-85, etc. MS3X/v3.57
http://www.buildpics.org/
Post Reply