Hi
I'm looking for so help on wiring up the Gen 1V cam sensor to a MS3 Ultimate that I have just purchased, I understand that the sensor needs a 5v supply which i can connect to one of the VREF 5V + outputs from the ECU and then connect the CMK + and a sensor return. The problem I have is with the connector pin designation, I can't seem to find any information on the connector I have, looking into the 3 pin connector with the locking tab up I have right to left A terminal red wire, B in the middle pink with black wire and C brown and white wire. Can you tell me which wire goes to where, or in idiot speak how I can test sensor to find out. Never done this before so bear with me and the engine hasn't been run before just finished building it
Regards Tim
GM LS Gen 1V Cam Sensor wiring problem
Moderators: jsmcortina, muythaibxr