Megatune "config error" when selecting Wasted spark...
Posted: Sun Dec 14, 2008 5:42 pm
This with MS2e release 2.0.1
When i go to select wasted spark or COP option in the tacho/ignition settings section and burn/reboot all the display gauges "freeze" and i cannot change anything with the jimstim. When i go back and change the wasted spark setting back to single coil+burn/reboot everything works just fine. I AM going to run wasted spark (all the addition drivers and associated wiring to the board is done) so i have to deal with this issue.
Could it be a hardware issue or software issue or?
Thanks in advance.
When i go to select wasted spark or COP option in the tacho/ignition settings section and burn/reboot all the display gauges "freeze" and i cannot change anything with the jimstim. When i go back and change the wasted spark setting back to single coil+burn/reboot everything works just fine. I AM going to run wasted spark (all the addition drivers and associated wiring to the board is done) so i have to deal with this issue.
Could it be a hardware issue or software issue or?
Thanks in advance.