problems turning off over run fuel cut

Questions specific to Megatune. (Only about the tuning software, not about MS1/MS2 code or code features)
Note that Megatune is obsolete.
Post Reply
alfanatiker
MS/Extra Newbie
Posts: 11
Joined: Thu May 28, 2015 12:19 am

problems turning off over run fuel cut

Post by alfanatiker »

I just started using my MS3X last Sunday, and yesterday I started with the autotune function. But I can't get off the over run fuel cut. It looks like it's of, but still my lambda shows 22,4 on overrun above 2000rpm and kpa lower than 35 (the numbers I put in there). This makes the autotune to increase the VE to stupid high on my lower points on the fuel table. 3100rpm and 40-30kpa for instance now getting up to 90% VE...
Matt Cramer
Super MS/Extra'er
Posts: 17499
Joined: Thu Apr 16, 2009 8:08 pm

Re: problems turning off over run fuel cut

Post by Matt Cramer »

:msq:
Matt Cramer -1966 Dodge Dart slant six running on MS3X
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: problems turning off over run fuel cut

Post by LT401Vette »

Are you actually using TunerStudio, not MegaTune? (I assume so as MegaTune doesn't support MS3)
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
alfanatiker
MS/Extra Newbie
Posts: 11
Joined: Thu May 28, 2015 12:19 am

Re: problems turning off over run fuel cut

Post by alfanatiker »

Sorry. Of course I´m using tunerstudio. I´ve started the same topic on the right place. Also I included a msq-file from the current tune.

http://www.msextra.com/forums/viewtopic ... 22&t=58892
Post Reply