Megasquirt Support Forum (MSEXTRA)

I just started using my MS3X last Sunday, and yesterday I started with the autotune function. But I can't get off the over run fuel cut. It looks like it's of, but still my lambda shows 22,4 on overrun above 2000rpm and kpa lower than 35 (the numbers I put in there). This makes the autotune to increase the VE to stupid high on my lower points on the fuel table. 3100rpm and 40-30kpa for instance now getting up to 90% VE...

Are you actually using TunerStudio, not MegaTune? (I assume so as MegaTune doesn't support MS3)

Sorry. Of course I´m using tunerstudio. I´ve started the same topic on the right place. Also I included a msq-file from the current tune.

http://www.msextra.com/forums/viewtopic ... 22&t=58892