problems turning off over run fuel cut
-
- MS/Extra Newbie
- Posts: 11
- Joined: Thu May 28, 2015 12:19 am
problems turning off over run fuel cut
I just started using my MS3X last Sunday, and yesterday I started with the autotune function. But I can't get off the over run fuel cut. It looks like it's of, but still my lambda shows 22,4 on overrun above 2000rpm and kpa lower than 35 (the numbers I put in there). This makes the autotune to increase the VE to stupid high on my lower points on the fuel table. 3100rpm and 40-30kpa for instance now getting up to 90% VE...
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: problems turning off over run fuel cut
Matt Cramer -1966 Dodge Dart slant six running on MS3X
-
- Super MS/Extra'er
- Posts: 12732
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: problems turning off over run fuel cut
Are you actually using TunerStudio, not MegaTune? (I assume so as MegaTune doesn't support MS3)
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- MS/Extra Newbie
- Posts: 11
- Joined: Thu May 28, 2015 12:19 am
Re: problems turning off over run fuel cut
Sorry. Of course I´m using tunerstudio. I´ve started the same topic on the right place. Also I included a msq-file from the current tune.
http://www.msextra.com/forums/viewtopic ... 22&t=58892
http://www.msextra.com/forums/viewtopic ... 22&t=58892