The readings seem opposite of each other, that when one reads lean, the other reads rich.
I set up the LC1 meter according to the specs sheet, MS seems to run the car well enough, but its not in synch.
Any ideas guys?
LC1 meter and megatune
-
- Helpful MS/Extra'er
- Posts: 123
- Joined: Fri Jan 13, 2006 5:29 pm
- Location: Up State NY
- Contact:
LC1 meter and megatune
1981 VW Scirocco w 2L 16v
-
- Super MS/Extra'er
- Posts: 12732
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: LC1 meter and megatune
MS1 or MS2?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Re: LC1 meter and megatune
There are 3 places you have to setup the LC1
- in the LM programmer
- In the configurator for the project you are using
- In the megatune calibration tool in the 'tools' menu (only if you're using MS2)
scirocco ;)
- in the LM programmer
- In the configurator for the project you are using
- In the megatune calibration tool in the 'tools' menu (only if you're using MS2)
scirocco ;)